SikaWall®-198 Finish 2-in-1 | Skim Coat for Exterior Wall (25kg)
Brand : Sika
Product Type : High performance, cementitious finish skimcoat for interior and exterior wall
Size : 25kg
Color : Grey Powder
Density : 1.04 kg/l
Composition : Cementitious mortar
Product Description:
SikaWall®-198 Finish 2-in-1 is a premium quality cementitious fine finishing coat specially formulated for skimming on wall and ceiling. SikaWall®-198 Finish 2-in-1 has smooth architectural finishing and superior adhesion strength.
Usage:
Suitable for application on:
- Concrete surfaces, lightweight concrete slabs, precast panels, soffits, brickwalls, lightweight aerated blocks and rendered surfaces
- Internal and external application
Features / Advantages:
- Provide a leveled and fine surface finish on walls, ceilings, etc.
- Better durability and flexibility
- Quick drying and easy to apply
- Thickness of the plaster can be variated to minimize wastage
- Non-combustible
- Non-cracking when applied at correct thickness and properly cured
- Easy to mix - just add water
- Good adhesion
- Can be applied by spraying
Shelf Life:
6 months from date of production
Storage Conditions:
Store properly in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +30 °C. Protect from direct sunlight, rain and water.
Application Guide:
Mixing Ratio : 7.75 - 8.75L per ba
Fresh Mortar Density : 1.60 - 1.70 kg/L (at +23 °C)
- Layer Thickness : 6mm (1-3mm thick per coat)
- Consumption : 1.3 -1.4 kg/m²/mm
- Dry powder
- Only a guideline, please carry-out trials on site for actual coverage.
Application Steps:
Step 1 : Mixing
- Pour clean water into a clean container, then add SikaWall®-198 Finish 2-in-1 while stirring continuously until a smooth consistency is achieved.
- Allow mixture to stand for a few minutes.
- Mix again and the plaster is ready for use.
Step 2 : Application
- Use steel trowel for application.
- Apply at recommended thickness of 1-3mm per layer and up to a total build-up thickness of 6mm.
- Ensure that each layer is dry before applying subsequent layer.
- Finished with a soft brush or troweled smooth.
Step 3 : Cleaning of Tools
- Clean all tools and application equipment with water immediately after use.
- Hardened or cured material can only be removed mechanically.
